Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Guardsman Duct Sealing & Repair: The Spring Owner’s Guide
We stock and install Guardsman-compatible duct sealing components and repair hardware for Spring homes, with typical installed pricing running $280-$520 depending on system reach and access. Most Guardsman seal jobs we book are completed same-day because we carry the mastic, foil tape, and mechanical fasteners that match Guardsman spec on every truck. Homeowners usually figure out something’s wrong when a room stops keeping temperature, their HVAC runs longer than it used to, or they spot dust puffing from a register seam - the seal has cracked or the joint has pulled apart.
Which Guardsman Models This Applies To
Guardsman doesn’t manufacture its own ductwork; the brand name shows up on sealing systems and repair kits installed by original builders and retrofit contractors across Spring, especially in subdivisions built between 2008 and 2018. If your home has Guardsman-branded mastic, foil tape, or mechanical sealing hardware, you’ll find the label on the plenum access panel, on a tag near the air handler, or stamped into metal collar clamps at main trunk junctions.
The critical compatibility gotcha: Guardsman spec tape is 2.8 mil aluminum foil with a synthetic rubber adhesive rated to 200°F continuous. Standard big-box foil tape is 1.5-2.0 mil with acrylic adhesive that hardens and releases around 150°F. In a Spring attic hitting 140°F in August, that difference matters. We match OEM spec or exceed it with aftermarket equivalent - Nikro foil tape at 3.0 mil, or Abatement Technologies mastic compound where the original Guardsman application has degraded past tape repair.
We also stock parts for Lennox, Trane, and Carrier systems when the sealing issue crosses into OEM equipment territory.
Signs Your Guardsman Duct Sealing & Repair Is Failing

- Uneven room temperatures. When the seal at a branch duct junction fails, conditioned air leaks into the attic or crawl space before reaching the register. The room at the end of that run gets starved; you crank the thermostat and the rest of the house gets cold.
- Dust blowing from register edges. A visible puff of particulate when the system kicks on means the duct run is pulling attic air through a gap on the return side, or pushing supply air out through a cracked mastic seam. The camera doesn’t negotiate - we photograph this every time.
- HVAC runtime stretching 20+ minutes past normal. Your system is producing the same BTUs, but losing 15-30% to leakage. The equipment runs longer, wears faster, and your bill climbs without changing the thermostat setting.
- Whistling or rushing air at joints. High-velocity noise from a plenum or trunk connection means a seal has failed completely and air is escaping under pressure. This is past the point of tape repair; the joint needs disassembly, cleaning, and re-sealing with fresh mastic.
- Spike in energy bills with no rate change. Spring’s cooling season runs long - May through October at full load. A failed Guardsman seal that went unnoticed in March becomes expensive fast once daily highs stay above 90°F.
Before
AfterReplacement Cost & What’s Included
| Scope | Price Range | What’s Covered |
|---|---|---|
| Single register or small branch repair | $280-$360 | Access, cleaning, re-seal with Guardsman-spec or equivalent material, photo documentation |
| Main trunk or plenum re-seal | $380-$520 | Disassembly of failed joint, surface prep, mastic application or mechanical fastening, pressure verification, full photo record |
| Multiple point failure (whole-system) | $520-$780 | Comprehensive seal audit, prioritized repair sequence, full documentation, 365-Day Done Right Promise |
What drives the range: access difficulty (attic crawl vs. open basement), whether the original Guardsman mastic can be repaired over or must be stripped and reapplied, and how many joints are involved. We deliver a written price before any work starts, per Haven Standard Clause 1. Every job includes the Documented Photo Record - before, during, after - delivered as part of your job file. The 365-Day Done Right Promise covers labor and materials; if the seal fails in that window, we return and make it right at no charge.
DIY or Call Us?

There’s a short list of things a homeowner can safely check: verify the filter isn’t clogged, confirm all registers are open and unblocked, and look for obvious disconnected flex duct in an accessible attic. That’s it.
Where DIY goes wrong: mastic application looks simple and isn’t. The surface must be clean and dry, the compound applied to the correct thickness (too thin cracks, too thick won’t cure), and the joint must remain undisturbed during cure time - 24 hours minimum, which means shutting down that duct run. In Spring’s humidity, surface prep alone defeats most homeowners. Worse, an incomplete seal masks the real problem while attic air keeps infiltrating. We’ve been called to jobs where a homeowner’s tape repair held three weeks, then peeled and took the original mastic with it.
We’re not affiliated with Guardsman - we’re an independent service provider - and we carry the correct materials on every truck. Call (346) 423-3631 for a free estimate with written pricing before we start.
FAQs
Properly applied Guardsman-spec mastic or foil tape lasts 10-15 years in Spring’s conditions, but attic heat cycling and humidity stress the adhesive interface. We’ve found homes near Gleannloch Farms - where clay-heavy soil and older construction create more foundation movement - tend to see joint stress at 8-10 years as ducts shift slightly. Call (346) 423-3631 and we’ll inspect with the camera before quoting.
Small cracks in intact mastic can be patched with compatible compound if the substrate is sound. If the original seal has separated from the metal, pulled away at edges, or shows crumbling throughout, we strip and reapply - patching over failure just traps moisture and accelerates decay. We photograph the condition and show you before deciding.
Most single-point repairs run 90 minutes to 2 hours. A main trunk or plenum re-seal takes 3-4 hours including cure verification. We schedule with realistic time blocks - no rushing the mastic cure, no sending you a bill for incomplete work.
Yes - Guardsman-spec foil tape, mastic compound, mechanical fasteners, and collar clamps are standard inventory on every CleanRun truck in Spring. If your system has an unusual fitting or transition piece, we source it same-day from our Houston-area supplier. We don’t book jobs we can’t finish.
Written by Tomas Reyes, Owner, CleanRun Air Duct Cleaning Spring at CleanRun Air Duct Cleaning Spring, serving Spring and nearby areas.




Before
After
Before
After